<listing id="l9bhj"><var id="l9bhj"></var></listing>
<var id="l9bhj"><strike id="l9bhj"></strike></var>
<menuitem id="l9bhj"></menuitem>
<cite id="l9bhj"><strike id="l9bhj"></strike></cite>
<cite id="l9bhj"><strike id="l9bhj"></strike></cite>
<var id="l9bhj"></var><cite id="l9bhj"><video id="l9bhj"></video></cite>
<menuitem id="l9bhj"></menuitem>
<cite id="l9bhj"><strike id="l9bhj"><listing id="l9bhj"></listing></strike></cite><cite id="l9bhj"><span id="l9bhj"><menuitem id="l9bhj"></menuitem></span></cite>
<var id="l9bhj"></var>
<var id="l9bhj"></var>
<var id="l9bhj"></var>
<var id="l9bhj"><strike id="l9bhj"></strike></var>
<ins id="l9bhj"><span id="l9bhj"></span></ins>
Volume 44 Issue 6
May  2022
Turn off MathJax
Article Contents
SUN Yan-guo, XU Cheng-shun, DU Xiu-li, WANG Pi-guang, Xi Ren-qiang, SUN Yi-long. Comparison of the bearing capacities of composite foundations for offshore wind turbines[J]. Chinese Journal of Engineering, 2022, 44(6): 1098-1107. doi: 10.13374/j.issn2095-9389.2021.04.07.007
Citation: SUN Yan-guo, XU Cheng-shun, DU Xiu-li, WANG Pi-guang, Xi Ren-qiang, SUN Yi-long. Comparison of the bearing capacities of composite foundations for offshore wind turbines[J]. Chinese Journal of Engineering, 2022, 44(6): 1098-1107. doi: 10.13374/j.issn2095-9389.2021.04.07.007

Comparison of the bearing capacities of composite foundations for offshore wind turbines

doi: 10.13374/j.issn2095-9389.2021.04.07.007
More Information
  • Corresponding author: E-mail: xuchengshun@bjut.edu.cn
  • Received Date: 2021-04-07
    Available Online: 2021-05-31
  • Publish Date: 2022-06-25
  • With the aggravation of energy shortage and environmental pollution, the development and utilization of renewable energy have become the focus of research in countries around the world. As a green renewable energy source, offshore wind energy is one of the effective ways to solve these problems. The foundation form of built offshore wind farms is mainly large-diameter monopile. With the development of offshore wind farms expanding toward the deep sea, the applicability of the large-diameter monopile is confronted with some significant challenges. The exploration and research of a new type of foundation are important and meaningful. Affected by the weight of the superstructure and the load of the marine environment, the design of offshore wind turbine foundations should consider the bearing performance of the foundation under vertical load, horizontal load, and bending moment. The ABAQUS software was used to compare the bearing capacities of large-diameter monopile, pile–plate composite foundation, and pile–bucket foundation in saturated clay under vertical load V, horizontal load H, and bending moment M. Results show that the bearing capacities of the two composite foundations are better than the bearing capacities of the monopile foundation. The vertical, horizontal, and bending bearing capacities of pile–plate composite foundations increase exponentially with the increase in the diameter of the plate. The vertical and bending bearing capacities of the pile–bucket foundation increase with the increase in the buried depth of the bucket structure increasing, and the increasing trend gradually weakens parallel to the line. The horizontal bearing capacity of the pile–bucket foundation has a linear relationship with the diameter and buried depth of the bucket structure in the soil. Under the composited loading conditions of VH and VM, the failure envelope spaces of the two composite foundations are larger than those of the monopile, and the bearing performance of the two composite foundations is significantly better than that of the monopile.

     

  • loading
  • [1]
    Díaz H, Soares C G. Review of the current status, technology and future trends of offshore wind farms. Ocean Eng, 2020, 209: 107381 doi: 10.1016/j.oceaneng.2020.107381
    [2]
    Wang X F, Zeng X W, Li J L, et al. A review on recent advancements of substructures for offshore wind turbines. Energy Convers Manag, 2018, 158: 103 doi: 10.1016/j.enconman.2017.12.061
    [3]
    Oh K Y, Nam W, Ryu M S, et al. A review of foundations of offshore wind energy convertors: Current status and future perspectives. Renew Sustain Energy Rev, 2018, 88: 16 doi: 10.1016/j.rser.2018.02.005
    [4]
    宋波, 趙偉娜, 雙妙. 沖刷深度對海上風電塔地震動力響應的影響分析. 工程科學學報, 2019, 41(10):1351

    Song B, Zhao W N, Shuang M. Analysis of the influence of scour depth on the dynamic response of offshore wind turbine towers under earthquake action. Chin J Eng, 2019, 41(10): 1351
    [5]
    Damiani R, Dykes K, Scott G. A comparison study of offshore wind support structures with monopiles and jackets for US waters. J Phys:Conf Ser, 2016, 753: 092003 doi: 10.1088/1742-6596/753/9/092003
    [6]
    Veers P, Dykes K, Lantz E, et al. Grand challenges in the science of wind energy. Science, 2019, 366(6464): 2027 doi: 10.1126/science.aau2027
    [7]
    Dnv G L. DNVGL-ST-0126: Support Structures for Wind Turbines. Oslo: DNV GL, 2016
    [8]
    International Electrotechnical Commission. IEC 61400-3 Wind turbines – Part 3: Design Requirements for Offshore Wind Turbines. Geneva: International Electrotechnical Commission, 2009
    [9]
    Yang Q, Yu P, Liu Y F, et al. Scour characteristics of an offshore umbrella suction anchor foundation under the combined actions of waves and currents. Ocean Eng, 2020, 202: 106701 doi: 10.1016/j.oceaneng.2019.106701
    [10]
    Li H J, Liu H J, Liu S Y. Dynamic analysis of umbrella suction anchor foundation embedded in seabed for offshore wind turbines. Geomech Energy Environ, 2017, 10: 12 doi: 10.1016/j.gete.2017.05.002
    [11]
    Wang X F, Zeng X W, Yang X, et al. Feasibility study of offshore wind turbines with hybrid monopile foundation based on centrifuge modeling. Appl Energy, 2018, 209: 127 doi: 10.1016/j.apenergy.2017.10.107
    [12]
    Anastasopoulos I, Theofilou M. Hybrid foundation for offshore wind turbines: Environmental and seismic loading. Soil Dyn Earthq Eng, 2016, 80: 192 doi: 10.1016/j.soildyn.2015.10.015
    [13]
    Lehane B M, Pedram B, Doherty J A, et al. Improved performance of monopiles when combined with footings for tower foundations in sand. J Geotech Geoenviron Eng, 2014, 140(7): 04014027 doi: 10.1061/(ASCE)GT.1943-5606.0001109
    [14]
    Stone K J L, Arshi H S, Zdravkovic L. Use of a bearing plate to enhance the lateral capacity of monopiles in sand. J Geotech Geoenviron Eng, 2018, 144(8): 04018051 doi: 10.1061/(ASCE)GT.1943-5606.0001913
    [15]
    朱東劍. 筒型基礎與單樁相結合的新型復合風電基礎研究[學位論文]. 天津: 天津大學, 2012

    Zhu D J. Research of a New Type of Foundation for Offshore Wind Turbines with the Combining of Monoplie Foundation and Bucket Foundation [Dissertation]. Tianjin: Tianjin University, 2012
    [16]
    劉潤, 李寶仁, 練繼建, 等. 海上風電單樁復合筒型基礎樁筒共同承載機制研究. 天津大學學報(自然科學與工程技術版), 2015, 48(5):429

    Liu R, Li B R, Lian J J, et al. Bearing characteristics of pile-bucket composite foundation for offshore wind turbine. J Tianjin Univ (Sci Technol), 2015, 48(5): 429
    [17]
    Chen D, Gao P, Huang S S, et al. Static and dynamic loading behavior of a hybrid foundation for offshore wind turbines. Mar Struct, 2020, 71: 102727 doi: 10.1016/j.marstruc.2020.102727
    [18]
    Hung L C, Kim S R. Evaluation of undrained bearing capacities of bucket foundations under combined loads. Mar Georesources Geotechnol, 2014, 32(1): 76 doi: 10.1080/1064119X.2012.735346
    [19]
    Mehravar M, Harireche O, Faramarzi A. Evaluation of undrained failure envelopes of caisson foundations under combined loading. Appl Ocean Res, 2016, 59: 129 doi: 10.1016/j.apor.2016.05.001
    [20]
    Hung L C, Kim S R. Evaluation of vertical and horizontal bearing capacities of bucket foundations in clay. Ocean Eng, 2012, 52: 75 doi: 10.1016/j.oceaneng.2012.06.001
    [21]
    范慶來, 欒茂田. V?H?T荷載空間內海上風機桶形基礎破壞包絡面特性分析. 土木工程學報, 2010, 43(4):113

    Fan Q L, Luan M T. Failure envelopes of bucket foundation for offshore wind turbines in V?H?T loading space. China Civ Eng J, 2010, 43(4): 113
    [22]
    Feng X, Randolph M F, Gourvenec S, et al. Design approach for rectangular mudmats under fully three-dimensional loading. Géotechnique, 2014, 64(1): 51
    [23]
    Tan F S. Centrifuge and theoretical modelling of conical footings on sand [Dissertation]. UK: University of Cambridge, 1990
  • 加載中

Catalog

    通訊作者: 陳斌, bchen63@163.com
    • 1. 

      沈陽化工大學材料科學與工程學院 沈陽 110142

    1. 本站搜索
    2. 百度學術搜索
    3. 萬方數據庫搜索
    4. CNKI搜索

    Figures(13)  / Tables(1)

    Article views (936) PDF downloads(55) Cited by()
    Proportional views
    Related

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return
    久色视频