Gasification desulfurization and resource utilization of ladle furnace refining slag

LIN Lu; HOU Zhong-xiao; BAO Yan-ping; WU Yu-xi; ZHANG Li-qiang; CENG Jia-qing

doi:10.13374/j.issn2095-9389.2018.s1.022

Volume 40 Issue S1

Dec. 2018

Turn off MathJax

Article Contents

Article Navigation > Chinese Journal of Engineering > 2018 > 40(S1): 154-160

LIN Lu, HOU Zhong-xiao, BAO Yan-ping, WU Yu-xi, ZHANG Li-qiang, CENG Jia-qing. Gasification desulfurization and resource utilization of ladle furnace refining slag[J]. Chinese Journal of Engineering, 2018, 40(S1): 154-160. doi: 10.13374/j.issn2095-9389.2018.s1.022

Citation:

LIN Lu, HOU Zhong-xiao, BAO Yan-ping, WU Yu-xi, ZHANG Li-qiang, CENG Jia-qing. Gasification desulfurization and resource utilization of ladle furnace refining slag[J]. Chinese Journal of Engineering, 2018, 40(S1): 154-160. doi: 10.13374/j.issn2095-9389.2018.s1.022

Citation:

PDF( 550 KB)

Gasification desulfurization and resource utilization of ladle furnace refining slag

doi: 10.13374/j.issn2095-9389.2018.s1.022

1. Metallurgical Technology Institute,Central Iron and Steel Research Institute;
2. Key Laboratory of Metallurgical Emission Reduction & Resources Recycling,Ministry of Education;
3. State Key Laboratory of Advanced Metallurgy,University of Science and Technology Beijing

Received Date: 2018-01-12
Available Online: 2023-07-18

Abstract

Abstract

The present situation and utilization mode of LF refining slag were investigated in detail for more than 30 typical iron and steel enterprises in China.It is found that the treatment method of LF refining slag is relatively simple, the utilization level is low and the waste of resources is serious.Meanwhile, LF refining slag is characterized by high optical basicity, high sulfur capacity, high sulfur distribution ratio, low melting temperature, and low viscosity.So LF refining slag could be recycled in smelting process, but sulfur enrichment is a restriction factor during the cyclic utilization.To solve this problem, the sulfur removal test and metallurgical recycling utilization of LF refining slag were carried out.The results show that sulfur in LF refining slag can be oxidized to SO₂by O₂, and it has good desulfurization result when blowing air into the slag at 1643 K and 1673 K.Sulfur removal at 10 min by blowing air is over47%, and over 90%at 60 min, and it can meet the sulfur content requirement of LF refining slag used for smelting process.Finally, a simple and efficient method of LF refining slag used for smelting process is proposed, which goes well with current steelmaking process.
- refining slag,
- sulfur removal,
- metallurgical recycling utilization,
- oxidation,
- sulfur enrichment

FullText(HTML)

References(16)

References

[1]	Liu H H. Research on theory and method of LF refining slag desulfurization. Shandong Metall, 2014, 36 (2) :46 (劉航航. LF精煉廢渣循環利用脫硫方法探討.山東冶金, 2014, 36 (2) :46)
[2]	Yi G L, Shi Y L. Studies on re-utilization of LF cold steel-making slag. Steelmaking, 2014, 30 (3) :46 (儀桂蘭, 史永林. LF冷態碳鋼精煉渣循環再利用的試驗研究.煉鋼, 2014, 30 (3) :46)
[3]	Yu H X, Wang X H, Wang M, et al. Desulfurization ability of refining slag with medium basicity. Int J Miner Metall Mater, 2014, 21 (12) :1160
[4]	Zhao L H, Lin L, Wu Q F. Experimental study on sulfur removal of LF refining slag in hot state by blowing air. Int J Miner Metall Mater, 2016, 23 (1) :33
[5]	Yu X W. Test analysis on hot state LF refining slag recycling.Shandong Metall, 2017, 39 (4) :34 (于學文. LF熱態精煉渣循環再利用試驗分析.山東冶金, 2017, 39 (4) :34)
[6]	He B T, Weng Y J, Li Y J, et al. Study on recycling utilization technology of refining slag in LF furnace. Hebei Metall, 2017 (8) :72 (賀保堂, 翁玉娟, 李彥軍, 等. LF爐精煉渣循環利用技術研究.河北冶金, 2017 (8) :72)
[7]	He H Y, Ni H W, Gan W G, et al. Sulfur’s existence form and sulf-phase forming mechanism in solidified refining slag. Iron Steel, 2009, 44 (3) :32 (何環宇, 倪紅衛, 甘萬貴, 等.精煉鋼渣硫賦存形式及含硫相形成機理.鋼鐵, 2009, 44 (3) :32)
[8]	Dippenaar R. Industrial uses of slag (the use and re-use of iron and steelmaking slags) . Ironmaking Steelmaking, 2005, 32 (1) :35
[9]	Ding G Y, Xu Z H, Shi C W, et al. Development and application of re-utilization technology of LF hot steel-making slag. Steelmaking, 2006, 22 (4) :12 (丁廣友, 徐志榮, 史翠薇, 等. LF熱態鋼渣循環再利用技術的開發與應用.煉鋼, 2006, 22 (4) :12)
[10]	Akitoshi M, Yu-ichi U, Naoki K, et al. Effects of temperature and oxygen potential on removal of sulfur from desulfurization slag. ISIJ Int, 2017, 57 (6) :1012
[11]	Cui Y Y, Wang D Y, Liu C J, et al. The novel technology of two-step roasting desulfurization for sulfur-bearing slag. Iron Steel Vanadium Titanium, 2013, 33 (6) :31 (崔玉元, 王德永, 劉承軍, 等.冶金廢渣“兩段式”焙燒脫硫新工藝研究.鋼鐵釩鈦, 2013, 33 (6) :31)
[12]	Huang Y, Xu G P, Cheng H G, et al. An overview of utilization of steel slag. Procedia Environmental Sciences, 2012, 16 (4) :791
[13]	Zhang J Y. Metallurgical Physical Chemistry. Beijing:Metallurgical industry press, 2009 (張家蕓.冶金物理化學.北京:冶金工業出版社, 2009)
[14]	Pelton A D, See J B, Elliott J F. Kinetics of evolution of SO2from hot metallurgical slags. Metall Trans, 1974, 5 (5) :1163
[15]	Wu S W, Wang S H, Jin S T. Kinetics of gas desulphurization in BOF slag. J Univ Sci Technol Beijing, 2000, 22 (3) :212 (吳勝文, 王書桓, 金山同.氣化脫硫動力學.北京科技大學學報, 2000, 22 (3) :212)
[16]	Wei S K, Wang K C. Thedesulphurization of molten slags in the gaseous phase during top-blown with air. Acta Metall Sinica, 1965, 8 (4) :420 (魏壽崑, 王國忱.空氣頂吹過程中熔渣的氣態脫硫.金屬學報, 1965, 8 (4) :420)