Corrosion behavior of 2507 duplex stainless steel in simulated SO<sub>2</sub>-Polluted seawater

ZHU Min; ZHU Tao; CHEN Ming; GUO Shao-yi; YUAN Yong-feng; YU Gao-hong; NIE Lun

doi:10.13374/j.issn2095-9389.2018.05.009

Volume 40 Issue 5

May 2018

Turn off MathJax

Article Contents

Article Navigation > Chinese Journal of Engineering > 2018 > 40(5): 587-593

ZHU Min, ZHU Tao, CHEN Ming, GUO Shao-yi, YUAN Yong-feng, YU Gao-hong, NIE Lun. Corrosion behavior of 2507 duplex stainless steel in simulated SO2-Polluted seawater[J]. Chinese Journal of Engineering, 2018, 40(5): 587-593. doi: 10.13374/j.issn2095-9389.2018.05.009

Citation:

ZHU Min, ZHU Tao, CHEN Ming, GUO Shao-yi, YUAN Yong-feng, YU Gao-hong, NIE Lun. Corrosion behavior of 2507 duplex stainless steel in simulated SO₂-Polluted seawater[J]. Chinese Journal of Engineering, 2018, 40(5): 587-593. doi: 10.13374/j.issn2095-9389.2018.05.009

Citation:

PDF( 3926 KB)

Corrosion behavior of 2507 duplex stainless steel in simulated SO₂-Polluted seawater

doi: 10.13374/j.issn2095-9389.2018.05.009

1) School of Mechanical Engineering and Automation, Zhejiang Sci-Tech University, Hangzhou 310018, China
2) Zhejiang Meili High Technology Co., Ltd., Xinchang 312500, China

Received Date: 2017-08-01

Abstract

Abstract

The corrosion behavior of 2507 duplex stainless steel in simulated seawater containing different concentrations of NaHSO₃ solution was investigated using open circuit potential, electrochemical impedance spectroscopy (EIS), Mott-Schottky curves, and an immersion corrosion test. The results depict that the open circuit potential shifts negatively with an increase in the concentration of NaHSO₃, whereas the corrosion tendency of the steel increases. The charge transfer resistance (R_t) decreases with the increased concentration of NaHSO₃, which suggests that the corrosion resistance is reduced. The corroded stainless steel exhibits localized pitting corrosion. Further, the degree of corrosion as well as the corrosion rate increases with an increase in the concentration of NaHSO₃. The results that are obtained using the Mott-Schottky curves and EIS test depict that the addition of NaHSO₃ increases the concentration of point defects on the passive surface film of 2507 stainless steel, reducing its stability and decreasing its charge transfer resistance, resulting in an increased probability of corrosion. This may be caused due to the fact that the addition of NaHSO₃ increases the acidity of the solution, which accelerates the damage that is caused to the passive film on the stainless steel.
- 2507 stainless steel,
- corrosion behavior,
- passive film,
- pitting corrosion,
- sodium hydrogen sulfite

FullText(HTML)

References(15)

References

[2]	Olaseinde O A, Van der Merwe J, Comish L. Characterization and corrosion behavior of selected duplex stainless steels in acidic and acidic-chloride solution. Adv Chem Eng Sci, 2014, 4(1):89
[3]	Du L N, Luan W X, Jiang Y P. Research on the development potential of China's strategic marine industries-marine engineering equipment manufacturing industry. Adv Mater Res, 2013, 694-697:3626
[7]	Zhang S C, Jiang Z H, Li H B, et al. Detection of susceptibility to intergranular corrosion of aged super austenitic stainless steel S32654 by a modified electrochemical potentiokinetic reactivation method. J Alloys Compd, 2017, 695:3083
[9]	Jin S, Liu C M, Lin X, et al. Effect of inorganic anions on the corrosion behavior of UNS S32750 duplex stainless steel in chloride solution. Mater Corros, 2015, 66(10):1077
[10]	Virgin L N, Davis R B. Vibration isolation using buckled struts. J Sound Vib, 2003, 260(5):965
[16]	Stefanoni M, Angst U, Elsener B. Local electrochemistry of reinforcement steel-distribution of open circuit and pitting potentials on steels with different surface condition. Corros Sci, 2015, 98:610
[18]	Ouyang W Z. Equivalent circuit for EIS study on rusted marine cast iron artifacts. Adv Mater Res, 2015, 1094:316
[19]	West W C, Hood Z D, Adhikari S P, et al. Reduction of charge-transfer resistance at the solid electrolyte-electrode interface by pulsed laser deposition of films from a crystalline Li₂PO₂N source. J Power Sources, 2016, 312:116
[20]	Cheng X Q, Li X G, Du C W. Properties of passive film formed on 316L/2205 stainless steel by Mott-Schottky theory and constant current polarization method. Chin Sci Bull, 2009, 54(13):2239
[22]	Alves V A, Brett C M A. Characterisation of passive films formed on mild steels in bicarbonate solution by EIS. Electrochim Acta, 2002, 47(13-14):2081
[23]	Sikora J, Sikora E, Macdonald D D. The electronic structure of the passive film on tungsten. Electrochim Acta, 2000, 45(12):1875
[24]	Krishnamurthy B, White R E, Ploehn H J. Non-equilibrium point defect model for time-dependent passivation of metal surfaces. Electrochim Acta, 2001, 46(22):3387
[25]	Ahn S J, Kim D Y, Kwon H S. Analysis of repassivation kinetics of Ti based on the point defect model. J Electrochem Soc, 2006, 153(9):B370
[26]	Zhang S S, Xu K, Jow T R. EIS study on the formation of solid electrolyte interface in Li-ion battery. Electrochim Acta, 2006, 51(8-9):1636
[28]	Zhang Z Q, Jing H Y, Xu L Y, et al. Effects of nitrogen in shielding gas on microstructure evolution and localized corrosion behavior of duplex stainless steel welding joint. Appl Surf Sci, 2017, 404:110