Machining Features Sequencing of Cross Wedge Rolling Tools

YANG Hongqing; WANG Baoyu; YANG Cuiping; HU Zhenghuan

doi:10.13374/j.issn1001-053x.2004.01.023

Volume 26 Issue 1

Aug. 2021

Turn off MathJax

Article Contents

Article Navigation > Chinese Journal of Engineering > 2004 > 26(1): 86-90

YANG Hongqing, WANG Baoyu, YANG Cuiping, HU Zhenghuan. Machining Features Sequencing of Cross Wedge Rolling Tools[J]. Chinese Journal of Engineering, 2004, 26(1): 86-90. doi: 10.13374/j.issn1001-053x.2004.01.023

Citation:

YANG Hongqing, WANG Baoyu, YANG Cuiping, HU Zhenghuan. Machining Features Sequencing of Cross Wedge Rolling Tools[J]. Chinese Journal of Engineering, 2004, 26(1): 86-90. doi: 10.13374/j.issn1001-053x.2004.01.023

Citation:

PDF( 518 KB)

Machining Features Sequencing of Cross Wedge Rolling Tools

doi: 10.13374/j.issn1001-053x.2004.01.023

Mechanical Engineering School, University of Science and Technology Beijing, Beijing 100083, China

Received Date: 2003-03-31

Abstract

Abstract

On the basis of the computer-aided design/computer-aided process planning (CAD/CAPP) integration information model of cross wedge rolling tools (CWRT), a machining features sequencing algorithm for CWRT was constructed with the creative decision-making method based on knowledge and VC++ object-oriented programming technique. Through properly arranging subtasks and defining constraints at different stages, the feasibility and agility of tool process planning were guaranteed. The practicability of this machining features sequencing algorithm was proved by analyzing a typical CWRT.
- CWRT,
- CAPP,
- machining features sequencing