Influence of Pole Figure Status on ODF Analysis

Zhao Zisu; Mao Weimin; Yu Yongning

doi:10.13374/j.issn1001-053x.1997.05.008

Volume 19 Issue 5

Sep. 2021

Turn off MathJax

Article Contents

Article Navigation > Chinese Journal of Engineering > 1997 > 19(5): 451-456

Zhao Zisu, Mao Weimin, Yu Yongning. Influence of Pole Figure Status on ODF Analysis[J]. Chinese Journal of Engineering, 1997, 19(5): 451-456. doi: 10.13374/j.issn1001-053x.1997.05.008

Citation:

Zhao Zisu, Mao Weimin, Yu Yongning. Influence of Pole Figure Status on ODF Analysis[J]. Chinese Journal of Engineering, 1997, 19(5): 451-456. doi: 10.13374/j.issn1001-053x.1997.05.008

Zhao Zisu, Mao Weimin, Yu Yongning. Influence of Pole Figure Status on ODF Analysis[J]. Chinese Journal of Engineering, 1997, 19(5): 451-456. doi: 10.13374/j.issn1001-053x.1997.05.008

Citation:

Zhao Zisu, Mao Weimin, Yu Yongning. Influence of Pole Figure Status on ODF Analysis[J]. Chinese Journal of Engineering, 1997, 19(5): 451-456. doi: 10.13374/j.issn1001-053x.1997.05.008

PDF( 481 KB)

Influence of Pole Figure Status on ODF Analysis

doi: 10.13374/j.issn1001-053x.1997.05.008

Material Science and Engineering School, UST Beijing, Beijing 100083, China

Received Date: 1996-05-08
Available Online: 2021-09-10

Abstract

Abstract

The influence of measurement condition and calculation method of the pole figure on the quality of ODF analysis is studied and the reasons are discussed. Some defects, which could result in obvious errors, are induced by the method of calculating ODF based on a quarter of the whole pole figure. It is suggested that the accuracy of ODF calculation can be increased by making the whole pole figure data average-weighted,and this method can also analyse the asymmetrical texture quantitatively and effectively.
- pole figure,
- ODF,
- texture