Flying Shears Controlled by the Micro-Computer Control System

Li Huade; Wu Xiaoming; Wang Jihai; Zhao Dianjia; Wang Shunhuang; Huang Chengyun

doi:10.13374/j.issn1001-053x.1987.02.010

Volume 9 Issue 2

Oct. 2021

Turn off MathJax

Article Contents

Article Navigation > Chinese Journal of Engineering > 1987 > 9(2): 69-72

Li Huade, Wu Xiaoming, Wang Jihai, Zhao Dianjia, Wang Shunhuang, Huang Chengyun. Flying Shears Controlled by the Micro-Computer Control System[J]. Chinese Journal of Engineering, 1987, 9(2): 69-72. doi: 10.13374/j.issn1001-053x.1987.02.010

Citation:

Li Huade, Wu Xiaoming, Wang Jihai, Zhao Dianjia, Wang Shunhuang, Huang Chengyun. Flying Shears Controlled by the Micro-Computer Control System[J]. Chinese Journal of Engineering, 1987, 9(2): 69-72. doi: 10.13374/j.issn1001-053x.1987.02.010

Citation:

PDF( 313 KB)

Flying Shears Controlled by the Micro-Computer Control System

doi: 10.13374/j.issn1001-053x.1987.02.010

Received Date: 1985-12-27
Available Online: 2021-10-28

Abstract

Abstract

A start-tyPe flying shear controlled by the micro-computer control system can complete the works of cut head and tail, cut-to-length and cut-to-average length for high speed continuous hot rod mill.Based on the Principle, it can descride the shearing errors and the method of improving accuracy.The hardware figures and softwares block diagrams of the system are Presented in this Paper.
It has been proved by the industrial scale experiment that the shearing eorror was decreased greatly.
- flying shear,
- micro-computer control,
- software,
- shearing eorror